Panasonic VB43060 VB43030 User Guide - Page 89
Terminal Programming Through DISA, Terminal Programming Through a CO Trunk and Operator Transfer
View all Panasonic VB43060 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 89 highlights
Section 700 - Operation Chapter 3. System Features 4. From your terminal communications program, type the following command: #99xxxx (where xxxx = the site's password) 5. After the DBS responds, type P and then press Enter. Follow the directions on the screen to access the desired program. (See "Terminal Programming Commands.") Terminal Programming Through DISA Note: The DBS must be equipped with an MFR card and a RAI card to allow terminal programming using this method. When programming through a DISA trunk, perform the following steps: 1. Dial into the DBS through a DISA trunk. 2. Once you are connected, type #69999 from your terminal communications program. 3. After the DBS responds with REMT>, type P and then press Enter. Follow the directions on the screen to access the desired program. (See "Terminal Programming Commands.") Terminal Programming Through a CO Trunk and Operator Transfer Note: The DBS must be equipped with an MFR card and a RAI card to allow terminal programming using this method. When programming through a normal trunk, perform the following steps: 1. Dial into the DBS through a normal trunk. 2. Ask the operator to place you on hold and dial #69999 to transfer you into remote programming. 3. After the DBS responds with REMT>, type P and then press Enter. Follow the directions on the screen to access the desired program. (See "Terminal Programming Commands.") DBS-2.3/9.2-700 DBS Manual - Revised April 2000 Page 3-43