Panasonic AJ-PX380GF Operating Instructions - Page 87
Error displays about proxy data recordings, Copying proxy data to the SD memory card
View all Panasonic AJ-PX380GF manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 87 highlights
Chapter 4 Shooting - Dual codec recording Error displays about proxy data recordings If an error occurs during recording the proxy data, check the entries in the following table and take necessary actions. Error displays (Viewfinder) [PROXY ERROR] or [PROXY REC WARNING] [SD 0 min] [SD END] [SD WR ERR] Behavior and cause Stops recording of proxy data. This may also stop recording of materials. ffAn error occurred in the internal proxy module. [PROXY ERROR] ffA proxy data recording error occurred. [PROXY REC WARNING] ffIf a proxy data recording error occurs, the proxy data currently being recorded will be processed as below: - The proxy data being recorded to the P2 card will be deleted. - The proxy data being recorded to the SD memory card will not be restored. Recording of the materials and proxy data will continue. ffThe remaining SD memory card capacity is getting low. (approximately shorter than one minute) Proxy data recording to the SD memory card will stop, but recording to the P2 card will continue. ffNo SD memory card capacity remains. Proxy data recording to the SD memory card will stop, but recording to the P2 card will continue. This is displayed when proxy data cannot be recorded in the SD memory card even when the main menu → [RECORDING SETUP] → [DUAL CODEC SETTING] → [CODEC USAGE] is set to [PROXY REC(P2&SD)]. Action to take The proxy data will not be properly recorded. Turn off the camera and turn on it again to check the recording and playback. If the error continues to occur, please consult your dealer. After finishing recording, insert a new SD memory card. After finishing recording, insert a new SD memory card. ffThe proxy data being recorded to the SD memory card will be deleted. To restore the deleted proxy data, select clips in the P2 card and copy them to the SD memory card. (page 87) Check the status of the SD memory card and insert a recordable card. (page 85) rr If the error message is displayed when recording starts: ffThe SD memory card format is different. ffThe SD memory card contains 1000 clips or more. [SD --min] or [SD WP] rr If the error message is displayed during recording: ffThe SD memory card was ejected during recording. ffAn error occurred in recording to the SD memory card. Proxy data will not be recorded to the SD memory card, but recording to the P2 card will be performed. ffNo SD memory card is inserted. [SD --min] ffThe SD memory card is write-protected. [SD WP] Check the status of the SD memory card. Copying proxy data to the SD memory card 1 Press the button to display the thumbnail screen. 2 Use the cursor buttons to move the cursor to the clip to be copied, and press the button. 3 Select [SD CARD] in the main menu → [CLIP] → [COPY]. 4 Select [YES] in the confirmation message and press the button. @@NOTE tt If [SD END] is displayed and the proxy data being recorded to the SD memory card is deleted, perform this procedure to copy the proxy data from the P2 card, and enable the deleted proxy data to be restored. tt Source data is not copied. - 87 -