NordicTrack Rw600 Instruction Manual - Page 9

7. Loosen and remove the Handle (78) from the Upright (77). Note: The Handle functions like a 7 ratchet. Turn the Handle in the desired direction, pull it outward, turn it in the opposite direction, push it inward, and then turn it in the desired direction again. Repeat this process as many times as necessary. Next, identify the Right and Left Upright Covers (80, 81), and orient them as shown. Tip: Avoid pinching the wires. Press the Right and Left Upright Covers (80, 81) together around the Upright (77), and attach them to the Upright with two M4 x 16mm Screws (68). Then, insert the Handle (78) into the Right Upright Cover (80) and tighten it into the Upright (77). 68 81 Avoid pinching the wires 77 80 78 68 8. While a second person holds the Console (75) near the Console Bracket (108), connect the connectors on the console wires (A) to the connectors on the Neck Wire (112). Then, insert the connectors into the Neck (76). Tip: It may be helpful to insert the connectors one at a time into the Neck. Next, press the Wire Protector (79) around the console wires (A), and press the Wire Protector into the Neck (76). Tip: Avoid pinching the wires. If necessary, tilt the Neck (76) upward to make this step easier. Attach the Console (75) to the Console Bracket (108) with four M4 x 16mm Screws (68); start all the Screws, and then tighten them. 8 108 75 Avoid pinching the wires 112 A 76 79 68 68 9