LiftMaster SL3000UL SL3000UL Manual - Page 17
Wiring, Earth Ground Installation - reviews
View all LiftMaster SL3000UL manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 17 highlights
Wiring WARNING To reduce the risk of SEVERE INJURY or DEATH: • DO NOT install ANY wiring or attempt to run the operator • ANY maintenance to the operator or in the area near the without consulting the wiring diagram. We recommend that operator MUST NOT be performed until disconnecting the you Install an optional reversing edge BEFORE proceeding electrical power and locking-out the power. Upon completion with the control station installation. WARNING of maintenance the area MUST be cleared and secured, at that • ALL power wiring should be on a dedicated circuit and well time the unit may be returned to service. protected. The location of the power disconnect should be • Disconnect power at the fuse box BEFORE proceeding. visible and clearly labeled. Operator MUST be properly grounded and connected in • ALL power and control wiring MUST be run in separate accordance with local electrical codes. conduit. WARNING NOTE: The operator should be on a separate fused line of • BEFORE installing power wiring or control stations be sure to adequate capacity. follow ALL specifications and warnings described below. • ALL electrical connections MUST be made by a qualified Failure to do so may result in SEVERE INJURY to persons and/ individual. WARNor IdaNmaGge to operator. WWAARRNNIINNGG All power wiring should be on a dedicated circuit and well protected. NOTE: Calculated using NEC guidelines. Local codes and conditions must be reviewed for suitability of wire installation. 120Vac Power Wire 1/2 HP and Dual Motor 1 HP 16 Gauge up to 150 FT up to 75 FT 14 Gauge 12 Gauge 250 FT CAUT400IOFT N 125 FT 200 FT 10 Gauge 650 FT 325 FT 8 Gauge 1000 FT 500 FT 4 Gauge 2200 FT 1100 FT W WAARRNNIINNGG ENGLISH To prevent SERIOUS INJURY or DEATH from a moving gate: DO NOT disconnect the built-in audio alarm or reset switch. Check local codes for proper depth. EARTH 3 Feet Single piece of 12 gauge wire. G R O U N D R O D I N S T A LL A T I O N ADVERTENCIA W CAAURTNIOINNG To AVOID damaging gas, power, or other underground utility lines, contact underground utility locating companies BEFORE digging. ENCAGUTLIONISH ADVERTENCIA Proper grounding gives an electrical charge, such as from an electrical static discharge or a near lightning strike, a path from which to dissipate its energy safely into the earth. ENADGVERLTIESNCHIA Without this path, the intense energy generated by lightning could be directed towards the gate operator. Although nothing can absorb the tremendous power ADVERTENCIA of a direct lightning strike, proper grounding can protect the gate operator in most cases. The earth ground rod must be located within 3 feet from the gate operator. Use the proper type earth ground rod for your local area. The ground wire must be a single, whole piece of wire. Never splice two AADDVVEERRTTEENNCCIIAA wires for the ground wire. If you should cut the ground wire too short, break it, or destroy its integrity, replace it with a single wire length. PRECAUCIÓN 15