LiftMaster LJ8900W LJ8900W Manual English French - Page 13
OPTION C: FLOOR INSTALLATION, INSTALLING THE BRACKETS, Fasten Wood Block to Wall
View all LiftMaster LJ8900W manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 13 highlights
Installation INSTALLING THE BRACKETS Be sure power to the operator is disconnected. Install and align the brackets so the safety reversing sensors will face each other across the door, with the beam no higher than 6" (15 cm) above the floor. Choose one of the following installations. OPTION A: TRACK INSTALLATION 1. Slip the curved arms over the rounded edge of each door track, with the curved arms facing the door. Snap into place against the side of the track. It should lie flush, with the lip hugging the back edge of the track, as shown. If your door track will not support the bracket securely, wall installation is recommended. Door Track Safety Reversing Sensor Bracket OPTION B: WALL INSTALLATION 1. Place the bracket against the wall with curved arms facing the door. Be sure there is enough clearance for the sensor beam to be unobstructed. 2. If additional depth is needed, an extension bracket (see Accessories) or wood blocks can be used. 3. Use bracket mounting holes as a template to locate and drill (2) 3/16" diameter pilot holes on the wall at each side of the door, no higher than 6" (15 cm) above the floor. 4. Attach brackets to wall with lag screws (not provided). If using extension brackets or wood blocks, adjust right and left assemblies to the same distance out from the mounting surface. Make sure all door hardware obstructions are cleared. OPTION C: FLOOR INSTALLATION 1. Use wood blocks or extension brackets (see Accessories) to elevate sensor brackets so the lenses will be no higher than 6" (15 cm) above the floor. 2. Carefully measure and place right and left assemblies at the same distance out from the wall. Be sure all door hardware obstructions are cleared. 3. Fasten to the floor with concrete anchors as shown. Fasten Wood Block to Wall with Lag Screws (not provided) Safety Reversing Sensor Bracket Lag Screws (not provided) Extension Bracket (See Accessories) (Provided with Extension Bracket) (Provided with Extension Bracket) Safety Reversing Sensor Bracket Attach with Concrete Anchors (not provided) Safety Reversing Sensor Bracket 13