LiftMaster EL25 EL25 - QUICK START KEYPAD PROGRAMMING Manual - Page 9

System Feedback / Responses (Beeps) The EL25 emits various audio tones to respond to input and to indicate certain conditions. Programming Single Unit Overview Programming Single Unit Overview Programming Responses: 2 Short Beeps: Programming step was valid. 3 Short Beeps: Programming mode was exited. 1 Long Beep: Input was not valid. 2 Long Beeps: Duplicate entry code was entered. 3 Long Beeps: Memory is full. 4 Long Beeps: Unit has reset or is powering up. Busy Signal: Line is busy or Do Not Disturb feature is in effect. Direct Command Responses: 5 Short Beeps: Gate is closing by command. 10 Short Beeps Gate is opening by command. Other Responses: 1 Short Beep: Key was pressed on the unit's keypad. 1 Beep: Talk time for a visitor call is lapsing and the unit will beep once per second for the last 10 seconds unless the talk time is extended. Ring Back: The unit is ringing the building. 10 Short Beeps: The unit has granted access. Silence: The keypad has struck out, the unit is being programmed from another source, or an alarm condition exists. Sending Direct Commands from the Resident's Phone (NPBI / Single Family Residence ONLY) You can send commands directly to the EL25 from your phone without being in programming mode. This feature is only available for a single-family residence or a manager is sharing a phone line with the EL25. To Enter a Direct Command from a Residence Phone: 1 Lift the receiver and press 1A If multiple EL25 units are sharing the same phone line, then a Unit ID Code (1-7) will need to be entered at this time. The unit is now ready to allow direct commands only! Example 1: Example 2: Enters direct command mode Enters direct command mode for unit three Page 8