Kenwood DPX-5000BT Operation Manual - Page 19

AUDIO SETTINGS SUBWOOFER SET FADER BALANCE VOLUME OFFSET SOUND EFFECT SOUND RECNSTR (Sound reconstruction) SPACE ENHANCE SND REALIZER STAGE EQ DRIVE EQ SPEAKER SIZE X ' OVER ON: Turns on the subwoofer output. ; OFF: Cancels. (Not applicable if 3-way crossover is selected.) R15 to F15 (0): Adjusts the rear and front speaker output balance. L15 to R15 (0): Adjusts the left and right speaker output balance. -15 to +6 (0): Preset the initial volume level of each source. (Before adjustment, select the source you want to adjust.) (Not applicable for TUNER source and AUX source.) ON: Creates realistic sound by compensating the high-frequency components and restoring the rise-time of the waveform that are lost in audio data compression. ; OFF: Cancels. (Not applicable for TUNER source.) SMALL/ MEDIUM/ LARGE: Virtually enhances the sound space. ; OFF: Cancels. LEVEL1/ LEVEL2/ LEVEL3: Virtually makes the sound more realistic. ; OFF: Cancels. LOW/ MIDDLE/ HIGH: Virtually adjust the sound position heard from the speakers. ; OFF: Cancels. ON: Boosts the frequency to reduce the noise heard from outside the car or running noise of the tyres. ; OFF: Cancels. Depending on the crossover type you have selected ( 5), 2-way crossover or 3-way crossover setting items will be shown. ( 19, 20) By default, 2-way crossover type is selected. • [SUB-W LEVEL] is selectable only if [SUBWOOFER SET] is set to [ON]. Crossover settings Below are the available setting items for 2-way crossover and 3-way crossover. SPEAKER SIZE Selects according to the connected speaker size for optimum performance. • The frequency and slope settings are automatically set for the crossover of the selected speaker. • If [NONE] is selected for [TWEETER] of [FRONT], [REAR] and [SUBWOOFER] for [SPEAKER SIZE], the [X ' OVER] setting of the speaker is not available. X ' OVER [FRQ]/ [F - HPF FRQ]/ [R - HPF FRQ]/ [SW LPF FRQ]/ [HPF FRQ]/ [LPF FRQ]: Adjusts the crossover frequency for the selected speakers (high pass filter or low pass filter). • If [THROUGH] is selected, all signals are sent to the selected speakers. [F - HPF SLOPE]/ [R - HPF SLOPE]/ [SW LPF SLOPE]/ [HPF SLOPE]/ [LPF SLOPE]/ [SLOPE]: Adjusts the crossover slope. • Selectable only if a setting other than [THROUGH] is selected for the crossover frequency. [SW LPF PHASE]/ [PHASE]: Selects the phase of the speaker output to be in line with the other speaker output. [GAIN LEFT]/ [GAIN RIGHT]/ [F - HPF GAIN]/ [R - HPF GAIN]/ [SW LPF GAIN]/ [GAIN]: Adjusts the output volume of the selected speaker. The following items is selectable only if [SUBWOOFER SET] is set to [ON]: - [SUBWOOFER]/ [WOOFER] of [SPEAKER SIZE] - [SUBWOOFER LPF]/ [WOOFER] of [X ' OVER] ENGLISH 19