Kenmore 35922 Owners Manual - Page 17

WARNING Electrical Shock Hazard Unplug power cord from electrical outlet. Do not operate the vacuum cleaner without the motor safety filter. Be sure the filter is dry and properly installed to prevent motor failure and/or electrical shock. MOTOR SAFETY FILTER Check motor safety filter frequently and clean when dirty. _._ _1_'_! ///l_ Filter Cover Filter Element- Remove the dust bag as outlined in the DUST BAG REPLACEMENT section. If the filter, located in the bottom of the dust cover cavity, is dirty, remove it by pulling forward out from under the ribs. Wash the foam filter in warm soapy water, rinse and dry thoroughly by squeezing the filter in your hand and letting it air dry. DO NOT wash in the dishwasher. DO NOT install damp. Replace the foam filter by sliding it back into place under the ribs in the dust cover cavity. Replace the dust bag as outlined in the DUST BAG REPLACEMENT section. The HEPA exhaust filter must be replaced when dirty. It should be replaced regularly depending on use conditions. The filter CANNOT be washed as it will lose its dust trapping ability. Note: See PARTS AND FEATURES for the exhaust filter number. Remove exhaust filter cover by pressing the release tab on the cover and rotating out from vacuum cleaner. \ The foam seal of the filter should be placed against the vacuum cleaner body. Exhaust Filter Seal Against Vacuum Cleaner Filter Cover Release Tab Remove the filter cartridge from cover. Exhaust Filter Replace the exhaust filter cover by placing bottom tabs in slots and rotating in until cover snaps into place. Place new filter cartridge into cover making sure that airflow arrow on side of cartridge points into cover. 17