Invacare PROX4S Owners Manual - Page 99
Securing the Occupant
View all Invacare PROX4S manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 99 highlights
Securing the Occupant SECTION 15-TRANSPORT READY OPTION Wheelchair-Anchored Belts ƽ WARNING The pelvic belt that is provided by Invacare has been tested for use in a motor vehicle on this wheelchair only. DO NOT replace the pelvic belt with a different style pelvic belt. NOTE: For this procedure, refer to FIGURE 15.2. The wheelchair has been provided with a pelvic belt which meets the requirements of ANSI/RESNA WC/19. The pelvic belt provided by Invacare has been designed to accommodate use on either side of the vehicle. If necessary, follow the instructions below to reverse the orientation of the pelvic belt to accommodate the vehicle‐anchored upper torso belt. 1. Install the pelvic belt pin (Detail ʺAʺ of FIGURE 15.2) into slot in the pelvic belt bracket. Pull upwards until it snaps into place. NOTE: Note the position of the male end of the belt when installing the pelvic belt onto the pelvic belt brackets. The male end of the pelvic belt (Detail ʺAʺ of FIGURE 15.2) has a pin which is used to secure the vehicle‐anchored upper torso belt. 2. Repeat STEP 1 for the opposite pelvic belt bracket. 3. Install the vehicle‐anchored upper torso belt onto the pin on the male end of the pelvic belt. DETAIL "A" Pelvic Belt Bracket Slot Pin Male End Pelvic End Pin Pin (Used to secure the vehicleanchored upper torso belt) Tie-Down Bracket FIGURE 15.2 Wheelchair-Anchored Belts Part No 1125104 99 ProSPIN™ X4™