Invacare PROX4S Owners Manual - Page 60
Adjustable Back Upholstery
View all Invacare PROX4S manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 60 highlights
SECTION 9-BACK Installing 1. Install the new back upholstery over mounted back cane. 2. Slide the loose back cane through the new back upholstery. 3. Using the mounted back cane as a guide, reinstall the loose back cane to the wheelchair frame with the existing back height adjustment screw and locknut. NOTE: For proper installation of the back upholstery, the back canes MUST be mounted in the same height adjustment hole. 4. Secure the new back upholstery to the back canes with the two mounting screws and washers. Torque to 20‐25 in‐lbs. 5. Secure the bottom of the new back upholstery to the wheelchair frame with tie‐wraps. Mounting Screw Washers Mounting Screw Back Upholstery Remove Back Cane FIGURE 9.5 Removing/Installing the Standard Back Upholstery Adjustable Back Upholstery Adjustable Tension Straps The adjuster straps can be adjusted at various levels of tension to accommodate individual end‐users. In a typical scenario, the bottom two straps can be adjusted tightly to support and/or assist the extensor muscles. Back Upholstery Cover The back upholstery cover is designed for three reasons: 1. The first is as a modesty cover. 2. The second is to keeps the cushion from sliding out of the back of the wheelchair. 3. The third is a sacral support depending upon how far or tight the seat portion of the back upholstery is pulled under the seat cushion. ProSPIN™ X4™ 60 Part No 1125104