HP PageWide Pro 750 Air Flow Repair Kit Install Guide - Page 6
Reinstall Tip
 |
View all HP PageWide Pro 750 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 6 highlights
3.3 1 3.4 1 Disconnect one connector (callout 1). REINSTALL TIP: Make sure to reconnect this connector when installing the formatter and formatter cage. When correctly installed, the line on the FFC is parallel to the connector body. Remove four screws. NOTE: One screw (callout 1) is captive and cannot be completely removed. 3.5 3.6 2 1 Rotate the bottom edge of the guide away from the printer (callout 1), and then slightly lift up on the formatter cage while rotating the bottom edge of the cage away from the printer (callout 2) to release it. Remove the formatter cage and back plate assembly. 6
-
1 -
2 -
3 -
4 -
5 -
6 -
7 -
8 -
9 -
10 -
11 -
12
 |
 |
1
1
1
2
6
3.5
3.6
Rotate the bottom edge of the guide away from the printer (callout 1), and
then slightly lift up on the formatter cage while rotating the bottom edge of
the cage away from the printer (callout 2) to release it.
Remove the formatter cage and back plate assembly.
3.3
3.4
Disconnect one connector (callout 1).
REINSTALL TIP:
Make sure to reconnect this connector when installing the
formatter and formatter cage. When correctly installed, the line on the FFC
is parallel to the connector body.
Remove four screws.
NOTE
: One screw (callout 1) is captive and cannot be completely removed.