Garmin Instinct Solar Owners Manual - Page 28
Device Maintenance, Troubleshooting
View all Garmin Instinct Solar manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 28 highlights
2 Disconnect the cable from your computer. Deleting Files NOTICE If you do not know the purpose of a file, do not delete it. Your device memory contains important system files that should not be deleted. 1 Open the Garmin drive or volume. 2 If necessary, open a folder or volume. 3 Select a file. 4 Press the Delete key on your keyboard. NOTE: If you are using an Apple computer, you must empty the Trash folder to completely remove the files. 2 Remove the band from the watch. Device Maintenance Device Care NOTICE Do not use a sharp object to clean the device. Avoid chemical cleaners, solvents, and insect repellents that can damage plastic components and finishes. Thoroughly rinse the device with fresh water after exposure to chlorine, salt water, sunscreen, cosmetics, alcohol, or other harsh chemicals. Prolonged exposure to these substances can damage the case. Avoid pressing the keys under water. Avoid extreme shock and harsh treatment, because it can degrade the life of the product. Do not store the device where prolonged exposure to extreme temperatures can occur, because it can cause permanent damage. Cleaning the Device NOTICE Even small amounts of sweat or moisture can cause corrosion of the electrical contacts when connected to a charger. Corrosion can prevent charging and data transfer. 1 Wipe the device using a cloth dampened with a mild detergent solution. 2 Wipe it dry. After cleaning, allow the device to dry completely. TIP: For more information, go to www.garmin.com/fitandcare. 3 Select an option: • To install Instinct bands, align one side of the new band with the holes on the device, push in the exposed watch pin, and press the band into place. NOTE: Make sure the band is secure. The watch pin should align with the holes on the device. • To install QuickFit 22 bands, remove the watch pin from the Instinct band, replace the watch pin on the device, and press the new band into place. Changing the Bands You can replace the bands with new Instinct bands or compatible QuickFit® 22 bands. 1 Use a paper clip to push in the watch pin. NOTE: Make sure the band is secure. The latch should close over the watch pin. 4 Repeat the steps to change the other band. Troubleshooting My device is in the wrong language You can change the device language selection if you have accidently selected the wrong language on the device. 1 Hold MENU. 2 Scroll down to the last item in the list, and press GPS. 24 Device Maintenance