Dynex DX-LDVD22-10A User Manual (English) - Page 12

8 Making connections Connecting an antenna or cable TV To connect an antenna, cable TV, or satellite TV box: 1 Connect one end of a 75 ohm cable (not included) to the RF OUT jack on the antenna or on the cable or satellite TV box. Multi-family dwellings or apartments Connect to wall antenna outlet. ANT/CABLE IN +'0 , 5 Select the channel you want with the remote control for the cable box. Back of TV 5 $ 8 ' ,2 ,1 / 6 9 ,' ( 2 ,1 5 $ 8 ' ,2 ,1 / 9 ,' ( 2 ,1 HDMI cable VHF antenna UHF antenna Wall antenna outlet Bronze wire - do not bend 75 ohm RF coaxial wire Turn clockwise to tighten & 2 0 3 2 1 ( 1 7,1 Bronze wire - do not bend Single-family dwellings or houses Connect to wall antenna jack for outdoor antenna. 2 Connect the other end of the cable to the ANT/CABLE IN jack on the back of your TV. Notes: Use a 75 ohm cable to eliminate interference and noise from radio waves. Do not bundle the 75 ohm cable with the power cord or other cables. If the antenna is not installed correctly, contact qualified service personnel to correct the problem. To improve picture quality in a poor signal area, purchase and install a signal amplifier. Connecting a cable TV or satellite box If you subscribe to a cable TV service from a local provider you can watch cable TV programming. The TV cannot display TV programming unless a TV tuner device or cable TV converter box is connected to the TV. For further information regarding cable TV service, contact your local cable TV service provider(s). To connect to a cable TV or satellite TV box: 1 Connect the incoming cable from the satellite wall jack to the SATELLITE IN jack on the satellite box. 2 Depending on the jacks available on the satellite TV receiver (set top box), connect a cable from the outgoing jacks on the satellite box to the corresponding jacks on the back of your TV. The connection can be to the HDMI, component video, S-Video, or AV jack. 3 If you use a component video, S-Video, or AV cable, connect audio cables to the corresponding jacks on the back of your TV and on the staellite box. 4 Turn on your TV, then press INPUT to select VIDEO mode for the type of connection you use. S-Video cable S-Video cable Cable box Connecting a VCR To connect a VCR (option 1): 1 Make sure that your TV's power cord is unplugged and the VCR is turned off. 2 Connect a 75 ohm RF wire to the ANT OUT jack on your VCR and to the ANT/CABLE IN jack on your TV (1), then switch the output of the VCR to 3 or 4 and tune your TV to the same channel. To connect a VCR (option 2): 1 Make sure that your TV's power cord is unplugged and the VCR is turned off. 2 Connect an AV cable to the AV VIDEO OUT jack on the VCR. Back of TV To VIDEO IN and AUDIO-L and R jacks 2 To S-VIDEO IN jack Note: Cables are often color-coded to connectors. Connect yellow to yellow, red to red, and white to white. AUDIO-L and R cables Video cable 3U 3E < R AUDIO IN L S-VIDEO IN R AUDIO IN L VIDEO IN Component video cables Pr Pb Y COMPONENT IN ANT/CABLE IN 1 VCR 75 ohm RF wire 3 Connect the other end of the cable to the VIDEO IN jack on the back of your TV.