Dell Inspiron 15 7572 Inspiron 15 7000 Service Manual - Page 28

Removing the display assembly, Prerequisites, Procedure

Get Dell Inspiron 15 7572 PDF manuals and user guides View all Dell Inspiron 15 7572 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 28 highlights

17 Removing the display assembly NOTE: Before working inside your computer, read the safety information that shipped with your computer and follow the steps in Before working inside your computer. After working inside your computer, follow the instructions in After working inside your computer. For more safety best practices, see the Regulatory Compliance home page at www.dell.com/regulatory_compliance. Prerequisites 1. Remove the base cover. 2. Remove the battery. 3. Remove the wireless card. Procedure 1. Note the routing and remove the antenna cables from the routing guides on the fan. 2. Open the latch and disconnect the display cable from the system board. 3. Open the display at an angle of 90 degrees. 4. Place the computer on the edge of a table so that the palm rest and keyboard assembly is on the table and the display assembly extends past the table edge with the display hinges facing up. 5. Remove the four screws (M2.5x5) that secure the display hinges to the palm rest and keyboard assembly. 6. Lift the display assembly off the palm rest and keyboard assembly. 28 Removing the display assembly

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
Removing the display assembly
NOTE:
Before working inside your computer, read the safety information that shipped with your computer and follow
the steps in
Before working inside your computer
. After working inside your computer, follow the instructions in
After
working inside your computer
. For more safety best practices, see the Regulatory Compliance home page at
www.dell.com/regulatory_compliance
.
Prerequisites
1.
Remove the
base cover
.
2.
Remove the
battery
.
3.
Remove the
wireless card
.
Procedure
1.
Note the routing and remove the antenna cables from the routing guides on the fan.
2.
Open the latch and disconnect the display cable from the system board.
3.
Open the display at an angle of 90 degrees.
4.
Place the computer on the edge of a table so that the palm rest and keyboard assembly is on the table and the display assembly
extends past the table edge with the display hinges facing up.
5.
Remove the four screws (M2.5x5) that secure the display hinges to the palm rest and keyboard assembly.
6.
Lift the display assembly off the palm rest and keyboard assembly.
17
28
Removing the display assembly