Ativa AT-BT110 Product Manual - Page 2

User Manual Bluetooth Headset AT-BT110 Headset pictures...1 Charging the battery...2 Turning on the Headset 2 Turning off the Headset 2 Headset in Pairing Mode 2 Establishing Bluetooth Link 3 Answering incoming calls 3 Transferring calls...3 Muting the microphone 3 Ending calls...3 To make a new call using voice dialing 4 Redialing last dialed number 4 Reject a call...4 Adjusting speaker volume 4 Right or left ear...4 Bend the ear hook to fit your ear 5 To put on the headset...5 Low-battery indication 6 Battery recharging...6 LED Status...7 Voice Over Internet Protocol (VOIP) Application 7 Declaration of Conformity 8 Office Depot Limited One Year Product Warranty 10 On/Off(S1) Volume Down(S3) Ear hook LED DC Socket Volume Up (S2) Microphone 1 Speaker Lock ! Charging the battery Thank you for buying the new AT-BT110 Headset with Bluetooth wireless technology. Before first time use, it is important to charge the battery for 6 hours. ! Turning on the Headset While the Headset is powered down, press and hold S1 until blue LED turn on. A low tone followed by a high tone will indicate that the AT-BT110 is powered up. Afterward, blue LED will flash every 3 seconds. ! Turning off the Headset While the Headset is powered up, press and hold S1 until red LED on. A high tone followed by a low tone will indicate that the AT-BT110 is powered down. ! Headset in Pairing Mode Make sure the AT-BT110 is fully charged and the charging cable is disconnected from it before pairing starts. While the AT-BT110 is powered off, press and hold S1 until red and blue LEDs flashing alternately. It indicates that the Headset is in Pairing Mode. Follow the operating instructions for your Bluetooth mobile phone to start the pairing process. Typically, this has to be done by going to a setup or connect menu and then selecting the options to discover Bluetooth devices. Bluetooth may take several seconds to establish a connection. Your phone's display should indicate that it has found the "AT-BT110" headset and asks if you want to pair it. You should confirm this. The phone's display would prompt you for a passkey or PIN. Enter a sequence of "0000". The headset LED will flash blue every 3 seconds, indicating successful pairing. Usually the phone will also ask whether you want to change the headset's name. We recommend you should approve the AT-BT110 name and not change it. You can pair as many headsets and devices as you wish in your mobile phone. If pairing does not occur as expected: Turn the headset and the phone off and wait for 10 seconds. Turn the headset and phone on again and repeat all steps from beginning. Pairing does authorize the devices like mobile phones and headsets with each other and only needs to be performed once. 2