Adaptec 2020SA User Guide - Page 114

Command Line Interface Enabling Automatic Failover To enable automatic failover, use the controller set automatic_failover command with the /failover switch, as in the following example: AAC0> controller set automatic_failover /failover_enabled=TRUE Executing: controller set automatic_failover /failover_enabled=TRUE After running the controller set automatic_failover command, use the controller show automatic_failover command to verify that automatic failover has been enabled. If necessary, you can now replace a failed disk with a replacement disk. Displaying Controller Information Controllers exhibit a number of attributes that you can display or manage using the following CLI commands: ■ Controller List ■ Controller Details Controller List The controller list attributes are defined as follows: ■ Adapter Name-Name ■ Adapter Type-Product name ■ Controller Availability-Access mode Example Before opening a controller, you may want to use the controller list command to display all controllers. In the following example, the Adapter Name column indicates that AAC0 is the name of the controller installed on the computer. The example also indicates the controller's path (\\.\). CLI> controller list Executing: controller list Adapter Name Adapter Type ------------ ------------ \\.\AAC0 Adaptec xxxxx Availability -----------read/write D-9