2010 Yamaha Motorsports FX Nytro RTX Owners Manual - Page 23
2010 Yamaha Motorsports FX Nytro RTX Manual
Page 23 highlights
Control functions ESU10722 ECS00830 Shroud and covers Securely fasten the shroud and covers before operating the snowmobile. (See page 42 for removal and installation procedures.) NOTICE Never run the engine with the V-belt removed. Clutch components can be damaged. The drive guard is designed to protect the Vbelt clutch and V-belt in case parts break or come loose. The drive guard is located behind the left side cover. (See page 42 for removal procedures.) 2 1 1 1. Shroud 2. Right side cover 2 1 1. Drive guard 2. Drive guard locking pin 1. Left side cover ESU12733 To remove the drive guard 1. Pull out the drive guard locking pin from the drive guard rear holder. 2. Lift up the rear of the drive guard as shown, and then pull the guard rearward to remove it. Drive guard EWS00401 WARNING G G Coming in contact with the rotating Vbelt or clutch parts can cause severe injury or death. Never run the engine with the drive guard removed. Make sure that the drive guard is tightened securely before operating the snowmobile to protect against severe injury or death from a broken V-belt or other part should it come off the snowmobile while it is in operation. To install the drive guard 1. Insert the projections on the drive guard front holder into the slots in the front of the drive guard. 17