2006 Yamaha Motorsports Virago 250 Owners Manual - Page 61
2006 Yamaha Motorsports Virago 250 Manual
Page 61 highlights
PERIODIC MAINTENANCE AND MINOR REPAIR Tightening torque: Axle nut: 104 Nm (10.4 m·kgf, 75 ft·lbf) 7. Adjust the brake pedal free play. (See page 6-20.) EWA10660 EAU23013 Cleaning and lubricating the drive chain The drive chain must be cleaned and lubricated at the intervals specified in the periodic maintenance and lubrication chart, otherwise it will quickly wear out, especially when riding in dusty or wet areas. Service the drive chain as follows. ECA10581 WARNING After adjusting the brake pedal free play, check the operation of the brake light. 6. Insert a new cotter pin into the axle nut, and then bend its ends as shown. CAUTION: The drive chain must be lubricated after washing the motorcycle and riding in the rain. 1. Cotter pin 1. Remove all dirt and mud from the drive chain with a brush or cloth. NOTE: For a thorough cleaning, have a Yamaha dealer remove the drive chain and soak it in solvent. 2. Spray Yamaha Chain and Cable Lube or a high-quality spray-type drive chain lubricant on both sides and on the middle of the chain, 6 NOTE: Make sure that two notches in the axle nut are aligned with the hole through the wheel axle, otherwise further tighten the axle nut until they are. EWA10700 WARNING Always use a new cotter pin for the axle nut. 6-25