2003 Yamaha Motorsports VMAX Owners Manual - Page 70
2003 Yamaha Motorsports VMAX Manual
Page 70 highlights
PERIODIC MAINTENANCE AND MINOR REPAIR Tightening torque: Water pump drain bolt: 43 Nm (4.3 m·kgf, 31 ft·lbf) 11. Install the rubber coolant drain plugs, and then install the cylinder drain plug covers. 1. Screw (× 4) 1. Rubber coolant drain plug (× 4) 7. Remove the cylinder drain plug covers on the outside of the cylinder blocks by removing the screws. 6 8. Remove the rubber coolant drain plugs to drain the coolant from the engine. 9. After the coolant is completely drained, thoroughly flush the cooling system with clean tap water. 10. Install the water pump drain bolt, and then tighten it to the specified torque. NOTE: Check the washer for damage and replace it if necessary. _ _ NOTE: Check the rubber plugs for damage and replace them if necessary. _ _ 12. Turn the coolant drain cock to "OFF". 13. Pour the recommended coolant into the reservoir to the maximum level, and then install the cap. 14. Pour the recommended coolant into the radiator until it is full. 6-19