2010 Volvo S80 Owner's Manual - Page 91
2010 Volvo S80 Manual
Page 91 highlights
03 Your driving environment Lighting 2. With the light switch in position , pull the turn signal lever toward the steering to toggle between wheel to position high and low beams (this also applies on models equipped with the optional Active Bending Lights). > The symbol illuminates in the instrument panel to indicate that the high beams are on. ABL is activated automatically when the engine is started and it can be deactivated/reactivated in the menu system under Car settings Light settings Active bi xenon lights. Parking lights NOTE This function is only active in twilight or dark conditions, and only when the vehicle is in motion. 03 If a fault should occur in the system, the symbol will illuminate and a message will be displayed as shown in the table. Headlight control in position for parking lights Symbol Display Headlamp failure Service required Explanation The system is not functioning properly and should be inspected/ repaired by a trained and qualified Volvo service technician. The front and rear parking lights can be turned on even when the ignition is switched off. Turn the headlight control to the center position (the license plate lighting comes on at the same time). The lighting also comes on when the trunk is opened in order to alert anyone traveling behind your vehicle. Headlight pattern with the Active Bending Light function deactivated (left) and activated (right) When this function is activated, the headlight beams adjust laterally to help light up a curve according to movements of the steering wheel (see the right-pointing beam in the illustration). G022907 Active Bending Lights (ABL)* `` * Option/accessory, for more information, see Introduction. 91