2008 Volvo S80 Owner's Manual - Page 252

Replacing the sealing compound container The sealing compound container must be replaced if: the tire sealing system has been used to repair a tire the container's expiration date has passed (see the date on decal). NOTE After use, the sealing compound bottle, the hose, and certain other system components must be replaced. Please consult your Volvo retailer for replacement parts. If the sealing compound bottle's expiration date has passed, please take it to a Volvo retailer or a recycling station that can properly dispose of harmful substances. 262 06 Maintenance and specifications Vehicle care Washing the car WARNING Be sure that the compressor is not connected to a 12-volt socket while replacing the container. The following points should be kept in mind when washing and cleaning the car: The car should be washed at regular intervals since dirt, dust, insects and tar spots adhere to the paint and may cause damage. To help prevent corrosion, it is particularly important to wash the car frequently in the wintertime. Avoid washing your car in direct sunlight. Doing so may cause detergents and wax to dry out and become abrasive. To avoid scratching, use lukewarm water to soften the dirt before you wash with a soft sponge, and plenty of sudsy water. Bird droppings : Remove from paintwork as soon as possible. Otherwise the finish may be permanently damaged. A detergent can be used to facilitate the softening of dirt and oil. A water-soluble grease solvent may be used in cases of sticky dirt. However, use a wash place equipped with a drainage separator. Dry the car with a clean chamois and remember to clean the drain holes in the doors and rocker panels. Tar spots can be removed with kerosene or tar remover after the car has been washed. A stiff-bristle brush and lukewarm soapy water can be used to clean the wiper blades. Frequent cleaning of the windshield and wiper blades improves visibility considerably and also helps prolong the service life of the wiper blades. Wash off the dirt from the underside (wheel housings, fenders, etc). In areas of high industrial fallout, more frequent washing is recommended. After cleaning the engine, the spark plug wells should be inspected for water and blown dry if necessary. NOTE When washing the car, remember to remove dirt from the drain holes in the doors and sills. CAUTION During high pressure washing, the spray mouthpiece must never be closer to the vehicle than 13" (30 cm). Do not spray into the locks.