2008 Volvo C70 Owner's Manual - Page 195
2008 Volvo C70 Manual
Page 195 highlights
Replacing bulbs Removing the headlight housing The entire headlight housing must be lifted out when replacing the high/low beam, parking light, turn signal, and side marker bulbs. To lift out the housing: 1. Remove the key from the ignition and turn the headlight switch to position 0. 2. Open the hood. 3. Pull up the headlight housing's retaining pin (1) 4. Pull the headlight housing to one side and then forward (2) 5. Disconnect the wiring connector by pressing down the clip with your thumb 6. (3) and pulling out the connector (4) with your other hand. 7. Lift out the headlight housing and place it on a soft surface to avoid scratching the lens. After the defective bulb has been replaced, reinsert the housing in the reverse order. Check that the retaining pin is correctly inserted. WARNING Bi-Xenon® headlights (option) - due to the high voltage used by these headlights, these bulbs should only be replaced by a trained and qualified Volvo service technician.