2015 Polaris Slingshot Owners Manual - Page 74
2015 Polaris Slingshot Manual
Page 74 highlights
MAINTENANCE Battery Battery Charging The following battery charging instructions apply only to the installation of a sealed battery. Read all instructions before proceeding with the installation of this battery. The sealed battery is already filled with electrolyte and has been sealed and fully charged at the factory. Never pry the sealing strip off or add any other fluid to this battery. The single most important thing about maintaining a sealed battery is to keep it fully charged. Since the battery is sealed and the sealing strip cannot be removed, you must use a voltmeter or multimeter to measure DC voltage. WARNING! An overheated battery may explode, causing severe injury or death. Always watch charging times carefully. Stop charging if the battery becomes very warm to the touch. Allow it to cool before resuming charging. For a refresh charge, follow all instructions carefully. 1. Check the battery voltage with a voltmeter or multimeter. A fully charged battery will register 12.8 V or higher. 2. If the voltage is less than 12.8 volts, recharge the battery at 1.8 amps until battery voltage is 12.8 or greater. 3. When using an automatic charger, refer to the charger manufacturer's instructions for recharging. 4. When using a constant current charger, use the guidelines below. Always verify battery condition before and 1-2 hours after the end of charging. State of Charge 100% 75%-100% Voltage (DC) 12.8-13.0 volts 12.6-12.8 volts Charge Time Action None, check again in 3 months May need slight charge, if no charge given, check in 3 months Needs charge Needs charge Needs charge (Using constant current charger @ standard amps specified on top of battery) None required 3-6 hours 50%-75% 25%-50% 0%-25% 12.3-12.6 volts 12.0-12.3 volts 12.0 volts or less 5-11 hours At least 13 hours At least 20 hours 72