2013 Polaris Ranger 500 Midsize Owners Manual - Page 63

2013 Polaris Ranger 500 Midsize Manual

Get 2013 Polaris Ranger 500 Midsize PDF manuals and user guides View all 2013 Polaris Ranger 500 Midsize manuals

Page 63 highlights

MAINTENANCE Throttle System WARNING Failure to check or maintain proper operation of the throttle system can result in an accident and lead to serious injury or death if the throttle pedal sticks during operation. Always check the pedal for free movement and return before starting the engine and occasionally during operation. Never start or operate this vehicle if it has a sticking or improperly operating throttle pedal. Immediately contact your dealer for service if throttle problems arise. Throttle Freeplay Inspection If the throttle pedal has excessive play due to cable stretch or misadjustment, it will cause a delay in throttle response, especially at low engine speed. The throttle may also not open fully. If the throttle pedal has no freeplay, the throttle may be hard to control, and the idle speed may be erratic. Check the throttle pedal freeplay at the intervals outlined in the Periodic Maintenance Chart beginning on page 43. Adjust the freeplay if necessary. Throttle 1. Place the transmission in PARK. Pedal 2. Start the engine. Allow it to warm up thoroughly. 3. Measure the distance the throttle pedal moves before the engine begins to pick up speed. Freeplay should be 1/16 to 1/8 inches (1.6-3.2 mm). Throttle Body/Idle RPM Idle RPM is preset by the manufacturer. If the engine idle speed is not satisfactory, please see your POLARIS dealer for adjustment. Throttle Freeplay Adjustment 1. 2. 3. 4. 5. Remove the lower seat base. Locate the throttle cable adjuster at the throttle body. Slide the cable adjuster boot away from the adjuster. Using a 10mm open-end wrench, loosen the adjustment jam nut. Using an 8mm open-end wrench, move the cable adjuster until 1/16 to 1/8 inches (1.63.2 mm) of freeplay is achieved at the throttle pedal. Tip: While adjusting, lightly move the throttle pedal up and down. 6. Tighten the jam nut. 7. Apply a small amount of all-purpose grease to the inside of the boot and slide it over the cable adjuster to its original position. 8. Reinstall the lower seat base. 9. Perform a test drive to ensure proper throttle operation. 59

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
  • 85
  • 86
  • 87
  • 88
  • 89
  • 90
  • 91
  • 92
  • 93
59
MAINTENANCE
Throttle System
Failure to check or maintain proper operation of the throttle system can result in an accident and lead to
serious injury or death if the throttle pedal sticks during operation.
Always check the pedal for free movement and return before starting the engine and occasionally
during operation. Never start or operate this vehicle if it has a sticking or improperly operating throttle
pedal. Immediately contact your dealer for service if throttle problems arise.
Throttle Freeplay Inspection
If the throttle pedal has excessive play due to cable stretch or
misadjustment, it will cause a delay in throttle response,
especially at low engine speed. The throttle may also not
open fully. If the throttle pedal has no freeplay, the throttle
may be hard to control, and the idle speed may be erratic.
Check the throttle pedal freeplay at the intervals outlined in
the Periodic Maintenance Chart beginning on page 43.
Adjust the freeplay if necessary.
1.
Place the transmission in PARK.
2.
Start the engine. Allow it to warm up thoroughly.
3.
Measure the distance the throttle pedal moves before the engine begins to pick up speed.
Freeplay should be 1/16 to 1/8 inches (1.6-3.2 mm).
Throttle Body/Idle RPM
Idle RPM is preset by the manufacturer. If the engine idle speed is not satisfactory, please see
your POLARIS dealer for adjustment.
Throttle Freeplay Adjustment
1.
Remove the lower seat base.
2.
Locate the throttle cable adjuster at the throttle body.
3.
Slide the cable adjuster boot away from the adjuster.
4.
Using a 10mm open-end wrench, loosen the adjustment jam nut.
5.
Using an 8mm open-end wrench, move the cable adjuster until 1/16 to 1/8 inches (1.6-
3.2 mm) of freeplay is achieved at the throttle pedal.
Tip:
While adjusting, lightly move the throttle pedal up and down.
6.
Tighten the jam nut.
7.
Apply a small amount of all-purpose grease to the inside of the boot and slide it over the
cable adjuster to its original position.
8.
Reinstall the lower seat base.
9.
Perform a test drive to ensure proper throttle operation.
WARNING
Throttle
Pedal