ZyXEL USG110/210/310 User Guide - Page 409

Chapter 11 Routing Figure 283 Configuration > Network > Routing > Policy Route The following table describes the labels in this screen. Table 137 Configuration > Network > Routing > Policy Route LABEL DESCRIPTION Show Advanced Settings / Hide Advanced Settings Enable BWM Click this button to display a greater or lesser number of configuration fields. This is a global setting for enabling or disabling bandwidth management on the Zyxel Device. You must enable this setting to have individual policy routes or application patrol policies apply bandwidth management. IPv4 Configuration / IPv6 Configuration Use IPv4/IPv6 Policy Route to Override Direct Route Add Edit Remove This same setting also appears in the AppPatrol > General screen. Enabling or disabling it in one screen also enables or disables it in the other screen. Use the IPv4 Configuration section for IPv4 network settings. Use the IPv6 Configuration section for IPv6 network settings if you connect your Zyxel Device to an IPv6 network. Both sections have similar fields as described below. Select this to have the Zyxel Device forward packets that match a policy route according to the policy route instead of sending the packets directly to a connected network. Click this to create a new entry. Select an entry and click Add to create a new entry after the selected entry. Double-click an entry or select it and click Edit to open a screen where you can modify the entry's settings. To remove an entry, select it and click Remove. The Zyxel Device confirms you want to remove it before doing so. ZyWALL USG Series User's Guide 409