ZyXEL USG110/210/310 User Guide - Page 275
LABEL, DESCRIPTION, Configuration > Wireless > Controller, Registration, Always Accept
View all ZyXEL USG110/210/310 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 275 highlights
Chapter 9 Wireless Each field is described in the following table. Table 90 Configuration > Wireless > AP Management > Mgnt. AP List LABEL DESCRIPTION Edit Select an AP and click this button to edit its properties. Remove Select an AP and click this button to remove it from the list. Reboot DCS Now Note: If in the Configuration > Wireless > Controller screen you set the Registration Type to Always Accept, then as soon as you remove an AP from this list it reconnects. Select an AP and click this button to force it to restart. Select one or multiple APs and click this button to use DCS (Dynamic Channel Selection) to allow the AP to automatically find a less-used channel in an environment where there are many APs and there may be interference. Note: You should have enabled DCS in the applied AP radio profile before the APs can use DCS. Log Suppression On Suppression Off # IP Address MAC Address Model R1 Mode / Profile / ZyMesh Profile R2 Mode / Profile / ZyMesh Profile Group Mgnt. VLAN ID(AC) Mgnt. VLAN ID(AP) Description Note: DCS is not supported on the radio which is working in repeater AP mode. Select an AP and click this button to go to the Monitor > Log > View AP Log screen to view the selected AP's current log messages. Select an AP and click this button to enable the AP's LED suppression mode. All the LEDs of the AP will turn off after the AP is ready. This button is not available if the selected AP doesn't support suppression mode. Select an AP and click this button to disable the AP's LED suppression mode. The AP LEDs stay lit after the AP is ready. This button is not available if the selected AP doesn't support suppression mode. This field is a sequential value, and it is not associated with any entry. This field displays the IP address of the AP. This field displays the MAC address of the AP. This field displays the AP's hardware model information. It displays N/A (not applicable) only when the AP disconnects from the Zyxel Device and the information is unavailable as a result. This field displays the operating mode (AP,MON, rootap, or repeater), AP radio profile name and ZyMesh profile name for Radio 1. It displays - for the ZyMesh profile for a radio not using a ZyMesh profile. This field displays the operating mode (AP, MON, rootap, or repeater), AP radio profile name and ZyMesh profile name for Radio 2. It displays - for the ZyMesh profile for a radio not using a ZyMesh profile. This field displays the name of the AP group to which the AP belongs. The group becomes editable immediately upon clicking. This displays the Access Controller (the Zyxel Device) management VLAN ID setting for the AP. This displays the runtime management VLAN ID setting on the AP. VLAN Conflict displays if the AP's management VLAN ID does not match the Mgnt. VLAN ID(AC). This field displays n/ a if the Zyxel Device cannot get VLAN information from the AP. This field displays the AP's description, which you can configure by selecting the AP's entry and clicking the Edit button. ZyWALL USG Series User's Guide 275