Zanussi ZWF842D1DG User Manual - Page 20

2. Touch the Delay Start button repeatedly until the display shows the desired delay time. 3. Touch the Start/Pause the new countdown. button again to start THE AUTOADJUST SYSTEM LOAD DETECTION The programme duration in the display is referred to a medium/high load. After touching the Start/Pause button, the AutoAdjust System starts the laundry load detection: 1. The appliance detects the load in the first 30 seconds. In the programmes where FlexiTime is available, during this phase the two dots separating hours from minutes are blinking and the drum rotates shortly. 2. The programme duration could be adjusted accordingly and could increase or decrease. After further 30 seconds, the water filling starts. About 20 minutes after the programme start, the programme duration could be adjusted again depending on the capacity of water absorption of the fabrics. The AutoAdjust detection is carried out with complete washing programmes only and if the programme duration has not been reduced. The AutoAdjust System is not available with all programmes such as :Wool, Rinse, Spin and programmes with short cycles. INTERRUPTING A PROGRAMME AND CHANGING THE OPTIONS When the programme is running, you can change only some options: 1. Touch the Start/Pause button. The related indicator flashes. 2. Change the options. The given information in the display changes accordingly. 3. Touch the button Start/Pause again. The washing programme continues. CANCELLING A RUNNING PROGRAMME 1. Press the button ON/OFF to cancel the programme and to deactivate the appliance. 2. Press the button ON/OFF again to activate the appliance. If the AutoAdjust System has completed and the water filling has already started, the new programme starts without repeating the AutoAdjust System. The water and the detergent are not drained out in order to avoid waste. The display shows the maximum duration of the programme, updating it about 20 minutes after the starting of the new programme. There is also an alternative way of cancelling: 1. Rotate the selector knob to the "Reset" position . 2. Wait for 1 second. The display shows . Now, you can set a new washing programme. OPENING THE DOOR - ADDING GARMENTS If the temperature and level of the water in the drum are too high and/or the drum is still rotating you should not open the door. While a programme or the delay start operates, the appliance door is locked. The display shows the indicator . 1. Touch the Start/Pause button. In the display the related door lock indicator goes off. 2. Open the appliance door. If necessary, add or remove the items. Close the door and touch the Start/Pause button. The programme or the delay start continues. 20