Zanussi ZBB28441SA Product Manaul - Page 10

Technical data - dimensions

Page 10 highlights

Problem There is too much frost. Possible cause Solution Food is not wrapped correctly. Wrap the food correctly. The door is not closed correctly. Refer to "Closing the door". The temperature regulator is not set Set a higher temperature. correctly. Replacing the lamp Caution! Disconnect the plug from the mains socket. 1 2 1 1. At the same time, with the fingers expand up and down the transparent cover and unhook it in the direction of the arrows. 2. Replace the lamp with one of the same power and shape, specifically designed for household appliances. (the maximum power is shown on the light bulb cover). 3. Reassemble the lamp cover. 4. Connect the plug to the mains socket. 5. Open the door. Make sure that the light comes on. Closing the door 1. Clean the door gaskets. 2. If necessary, adjust the door. Refer to "In- stallation". Technical data 3. If necessary, replace the defective door gaskets. Contact the Service Center. Dimension of the recess Rising Time Voltage Frequency Height Width Depth The technical information are situated in the rating plate on the internal left side of the appliance and in the energy label. 1780 mm 560 mm 550 mm 22 h 230-240 V 50 Hz 10 www.zanussi.com

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16

Problem
Possible cause
Solution
There is too much frost.
Food is not wrapped correctly.
Wrap the food correctly.
The door is not closed correctly.
Refer to "Closing the door".
The temperature regulator is not set
correctly.
Set a higher temperature.
Replacing the lamp
Caution!
Disconnect the plug from the
mains socket.
1
1
2
1.
At the same time, with the fingers expand up
and down the transparent cover and unhook it
in the direction of the arrows.
2.
Replace the lamp with one of the same power
and shape, specifically designed for house-
hold appliances. (the maximum power is
shown on the light bulb cover).
3.
Reassemble the lamp cover.
4.
Connect the plug to the mains socket.
5.
Open the door. Make sure that the light
comes on.
Closing the door
1.
Clean the door gaskets.
2.
If necessary, adjust the door. Refer to "In-
stallation".
3.
If necessary, replace the defective door
gaskets. Contact the Service Center.
Technical data
Dimension of the recess
Height
1780 mm
Width
560 mm
Depth
550 mm
Rising Time
22 h
Voltage
230-240 V
Frequency
50 Hz
The technical information are situated in the rat-
ing plate on the internal left side of the appli-
ance and in the energy label.
10
www.zanussi.com