Zanussi ZBB28441SA Product Manaul

Zanussi ZBB28441SA Manual

Zanussi ZBB28441SA manual content summary:

  • Zanussi ZBB28441SA | Product Manaul - Page 1
    EN User manual Fridge-Freezer ZBB28441SA
  • Zanussi ZBB28441SA | Product Manaul - Page 2
    11 Environmental concerns 14 Subject to change without notice. Safety instructions In the interest of your safety and to ensure the correct use, before installing and first using the appliance, read this user manual carefully, including its hints and warnings. To avoid unnecessary mistakes
  • Zanussi ZBB28441SA | Product Manaul - Page 3
    service agent or qualified service parts in the appliance. www.zanussi.com • Do not store flammable gas and liquid in the appliance bottom of the appliance. Installation Important! For electrical connection carefully follow the instructions given in specific paragraphs. • Unpack the appliance
  • Zanussi ZBB28441SA | Product Manaul - Page 4
    ventilation follow the instructions relevant to installation. • Wherever possible the back of the product should be against a wall to avoid touching or catching warm parts (compressor, condenser) to prevent possible burn. • The appliance must not be located close to radiators or cookers. • Make sure
  • Zanussi ZBB28441SA | Product Manaul - Page 5
    , remove all drawers and baskets from appliance and place food freezer compartment. Important! Do not use metallic instruments to remove the trays from the freezer. The walls of the refrigerator are equipped with a series of supports so that the shelves can be positioned as desired. www.zanussi
  • Zanussi ZBB28441SA | Product Manaul - Page 6
    necessary. • If the ambient temperature is high and the Temperature Regulator is set to low temperature and the appliance is fully loaded, the : wrap in polythene bags and place on the glass shelf above the vegetable drawer. For safety, store in this way only one or two days at the .zanussi.com
  • Zanussi ZBB28441SA | Product Manaul - Page 7
    temperature of the latter; • lean foods store better and longer than fatty ones; salt reduces the storage life of food; • water ices, if consumed immediately after removal from the freezer back of the appliance with a brush. This operation will improve the performance of the appliance and save
  • Zanussi ZBB28441SA | Product Manaul - Page 8
    Temperature regulator toward higher settings , in order to build up sufficient chill reserve for the interruption in operation. To remove the frost, follow the instructions below: 1. Switch off the appliance place a pot of warm water in the freezer compartment. In addition, remove pieces of ice that
  • Zanussi ZBB28441SA | Product Manaul - Page 9
    troubleshooting that is not in this manual. Important! There are some sounds during normal use (compressor, refrigerant circulation). Problem Possible cause Solution The appliance the appliance. Make sure that there is cold air circulation in the appliance. The temperature in the freezer is
  • Zanussi ZBB28441SA | Product Manaul - Page 10
    . Contact the Service Center. Dimension of the recess Rising Time Voltage Frequency Height Width Depth The technical information are situated in the rating plate on the internal left side of the appliance and in the energy label. 1780 mm 560 mm 550 mm 22 h 230-240 V 50 Hz 10 www.zanussi.com
  • Zanussi ZBB28441SA | Product Manaul - Page 11
    and correct operation of the appliance before installing the appliance. Positioning Install this appliance at a location where the ambient temperature corresponds to the climate class indicated on the rating plate of the appliance: Climate class SN N ST T Ambient temperature +10°C to + 32°C +16
  • Zanussi ZBB28441SA | Product Manaul - Page 12
    in figure. 2 Install the appliance in the niche. Push the appliance in the direction of the arrows (1) until the upper gap cover stops against the kitchen furniture. Push the appliance in the direction of the arrows (2) against the cupboard on the opposite side of the hinge. 12 www.zanussi.com
  • Zanussi ZBB28441SA | Product Manaul - Page 13
    the screws of the part (G) again. 3. Attach the part (H) to the part (G). 8 Disconnect the parts (Ha), (Hb), (Hc) and (Hd). ~50 mm 90o Ha 21 mm 90o ~50 mm 21 mm Hc 9 Install the part (Ha) on the inner side of the kitchen furniture. 10 Push the part (Hc) on the part (Ha). www.zanussi.com 13
  • Zanussi ZBB28441SA | Product Manaul - Page 14
    increases when the ambient temperature increases. Hb Hb Hd 13 Place the small 14 Press the part square on the guide (Hd) on the part (Hb). again and fix it with the screws supplied. Align the kitchen furniture door and the appliance door by adjusting the part (Hb). Environmental concerns The
  • Zanussi ZBB28441SA | Product Manaul - Page 15
    www.zanussi.com 15
  • Zanussi ZBB28441SA | Product Manaul - Page 16
    222365411-A-032013 www.zanussi.com/shop
  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16

EN
User manual
Fridge-Freezer
ZBB28441SA