Vtech vt1970 User Manual - Page 36

OPERATING YOUR VT 1970ci ANSWERING DEVICE ERASE Key • Press the ERASE key during playback of a message to delete that message. • When the answering device is inactive, press and hold the ERASE key for more than 2 seconds to delete all old (previously heard) messages. REPEAT Key • Press this key during message playback to return to the beginning of the message. PLAY/STOP Key • Press this key to begin message playback. When pressed, the voice prompt will tell you the number of new and old messages stored in memory. If there are any new (unplayed) messages, the VT 1970ciwill play them and STOP. You can then press PLAY/STOP again to review old messages. • Press this key to STOP message playback. • Press this key to exit answering device programming mode. SKIP/QUICK Key • During message playback, press this key to advance to the next message. • Hold this key down during message playback to increase playback speed. VOLUME UP/DOWN Keys • These keys control the loudness of the Base Unit speaker. At the lowest setting (1), you will not hear incoming messages. To screen calls as they come in, raise the volume level from the minimum setting (1). 7 is the loudest setting. MENU, SELECT, TIME/SET Keys • These keys are used for answering device setup. See "Setting Up YourVT1970ciDigital Answering Device". MENU SELECT TIME/SET VOLUME UP VOLUME DOWN SKIP/QUICK vt1970ci/hjmannual ERASE REPEAT PLAY/STOP 36 36 1/29/99, 12:52 PM