Viper 5002 Owner Manual - Page 24

passive arming The system can be programmed to arm itself automatically (called passive arming). If the system is programmed for passive arming, it will automatically arm 30 seconds after the ignition is turned off and the system detects that you have left the vehicle by opening and closing a door. Whenever the system is in its 30-second passive arming countdown, the in-vehicle status LED will flash twice as fast as it does when the system is armed. At the 20-second point of the countdown, the siren will chirp to indicate that the system is about to arm. At the 30-second point, the parking lights will flash to indicate that the system is armed. The LCD remote responds to passive arming with one beep and the icon will flash 3-times to indicate successful arming of the system. note: If any protected entry point (such as a door or a switch-protected trunk or hood) is open, the system will not passively arm (unless forced passive arming is programmed on. See Programming Options section.) Additionally, if a door, hood or trunk is triggered during the arming countdown, the 30-second countdown starts over. When armed your vehicle is protected as follows: ➤ Light impacts trigger the Warn Away® signal. When triggered, the siren chirps and the parking lights flash for a few seconds. ➤ Heavy impacts trip a Triggered Sequence. The sequence consists of the siren sounding continuously and the parking lights flashing for a pre-programmed period, which can range in duration from 1 to 180 seconds. ➤ If a door is opened, the system will immediately start © 2006 directed electronics 19