Viper 1002 Owner Manual - Page 39
shock sensor adjustment
View all Viper 1002 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 39 highlights
shock sensor adjustment ➜ enter shock sensor adjustment mode important: Prior to performing this procedure the system must be disarmed, the doors, trunk and hood must be closed, and the ignition must be Off. 1. Press and hold and buttons for 4-seconds. 2. The system will emit 1 long chirp to indicate entry into shock adjustment mode. 3. The LED will illuminate continuously for the duration of shock adjustment mode. note: When the shock sensor adjustment mode is entered, all other timers and operations are bypassed until adjustment mode is exited. ➜ adjusting the shock sensor setting 1. Increase Sensitivity-Press and release the button to increase shock sensor sensitivity by one step. The siren will chirp 2-times for each step increased in adjustment. When the shock sensor adjustment reaches maximum sensitivity the siren will emit 2 short chirps and then 1 long chirp. note: When the arm and disarm are programmed to a single button, then the AUX button is used to increase the sensitivity setting of the sensor. 34 © 2006 directed electronics