URC THZ-100 Owners Manual - Page 33

Resetting the Filter Reminder

Get URC THZ-100 PDF manuals and user guides View all URC THZ-100 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 33 highlights

THZ-100 THERMOSTAT Resetting the Filter Reminder If a filter reminder time was setup through the MRX Advanced Network System Controller when your thermostat was initially setup, then you will periodically get a Check: Filter message on the main screen of the thermostat. To clear the Check: Filter message from the thermostat screen after the filter has been replaced; use the arrow keys to move the highlight bar to Filter Reminder. Press the key below the OK key label in the smart-key label at the bottom right of the display to select this new information screen. If you decide to cancel the operation then press the key below the Go Back key label in the smart-key label at the bottom left of the display. The display updates to show Filter Reminder Reset at the top of the screen and the following message in the center of the screen Your filter reminder is going to be reset. You will be notified in to change it again. The X displays the number of months designated at the initial thermostat setup. A graphic, adjacent to the Filter Reminder, appears to signify that the Filter Reminder has gone off. Press the key below the OK key label in the smart-key label at the bottom right of the display to reset the reminder. If you decide to cancel the operation then press the key below the Cancel key label in the smart-key label at the bottom left of the display. Page 29

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
Page 29
THZ-100 T
HERMOSTAT
Resetting the Filter Reminder
If a filter reminder time was setup through the MRX Advanced
Network System Controller when your thermostat was initially
setup, then you will periodically get a
Check: Filter
message on the
main screen of the thermostat.
To clear the
Check: Filter
message from the thermostat screen after
the filter has been replaced; use the arrow keys to move the
highlight bar to
Filter Reminder
.
Press the key below the
OK
key label in the smart-key label at the
bottom right of the display to select this new information screen. If
you decide to cancel the operation then press the key below the
Go
Back
key label in the smart-key label at the bottom left of the
display.
The display updates to show
Filter Reminder Reset
at the top of the
screen and the following message in the center of the screen
Your
filter reminder is going to be reset. You will be notified in <X
Months> to change it again
. The
X
displays the number of months
designated at the initial thermostat setup.
A graphic, adjacent to the Filter Reminder, appears to signify that the
Filter Reminder has gone off.
Press the key below the
OK
key label in the smart-key label at the
bottom right of the display to reset the reminder. If you decide to
cancel the operation then press the key below the
Cancel
key label
in the smart-key label at the bottom left of the display.