URC MX-600 Owners Manual - Page 22
Learning to VOL, CH and Transport buttons: If
View all URC MX-600 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 22 highlights
5. Programming the MX-600 to Control Your Components 6. Press the button on the MX-600 you wish to program. Only the three MAIN, PAGE and FAV buttons cannot be programmed. 7. Press the button on your original remote control that you wish to program onto the MX-600. Once the MX-600 has received the signal, the MX-600 will flash "Good" on the LCD screen, indicating it learned the code correctly. (Please do Step #6 within 20 seconds of Step #5, otherwise the remote will revert to the SETUP menu, and then after a period of time, it will go back to the MAIN device page.) If it flashes "Fail", repeat from Step 4 until it learns successfully. 8. Return to Step #3 until you have programmed all of the buttons that you require. 9. Once you complete the programming and wish to exit the LEARNING mode, press the MAIN button. Exit from the SET UP mode by pressing the MAIN button once again. Tip: Learning to VOL, CH and Transport buttons: If you are having problems learning to the Volume, Channel and Transport buttons, it may be that you have previously assigned a "Punch Through" from another device to that device. To remove a Punch Through, just punch through the device to itself. For example, to erase a punch through from a TV to an Audio Device, just punch through the TV to the TV. (See "Programming Punch Through" functions on Page 32.) 21