URC MRX-8 Owners Manual

URC MRX-8 Manual

Get URC MRX-8 PDF manuals and user guides View all URC MRX-8 manuals
Add to My Manuals
Save this manual to your list of manuals

URC MRX-8 manual content summary:

  • URC MRX-8 | Owners Manual - Page 1
    Owner's Manual MRX-8 System Controller
  • URC MRX-8 | Owners Manual - Page 2
    , TECHNICAL OR EDITORIAL ERRORS/OMISSIONS MADE IN THIS MANUAL. The information in this owner's manual may be subject to change without prior notice. Total Control is a registered trademark of Universal Remote Control, Inc. URC - Control the Experience is a registered trademark of Universal Remote
  • URC MRX-8 | Owners Manual - Page 3
    TABLE OF CONTENTS Introduction 1 Features and Benefits 1 Parts Guide 1 Front Panel Descriptions 2 Rear Panel Descriptions 3 Installing the MRX-8 4 Specifications 8 Limited Warranty Statement 9 End User Agreement 11 Federal Communication Commission Interference Statement 12
  • URC MRX-8 | Owners Manual - Page 4
    on purchasing the Total Control MRX-8 System Controller for automation and control. Using the Total Control line of interfaces provides you full access and control for every compatible device using IR, IP, RS-232, and Relays. This network based control is also compatible with URC sensors, like audio
  • URC MRX-8 | Owners Manual - Page 5
    TOTAL CONTROL MRX-8 SYSTEM CONTROLLER Front Panel Descriptions The front panel consists of two indicator lights which illuminate when in use. Power LED Ethernet LED Power LED: Indicates that the MRX-8 is powered on when lit. Ethernet LED: Indicates the network connectivity status: ● On = Connected ●
  • URC MRX-8 | Owners Manual - Page 6
    TOTAL CONTROL MRX-8 SYSTEM CONTROLLER Rear Panel Descriptions The rear panel ports are: LAN RS-232 Ports IR /.5A. RS-232: Two RS-232 ports support Tx(Transmit), Rx(Receive) and GND(Ground) connections for two-way communication. Compatible with URC cables RS232F and RS232M. Sensors: Two sensor
  • URC MRX-8 | Owners Manual - Page 7
    TOTAL CONTROL MRX-8 SYSTEM CONTROLLER Installing the MRX-8 Physical Installation of the MRX-8 and Accessories The MRX-8 System Controller can be installed anywhere in the home or office network. Once installed, program it to operate all local equipment using IP/Network, IR, RS-232, or Relays. As
  • URC MRX-8 | Owners Manual - Page 8
    guide and test the navigation arrows. Compare operation via RF to the original remote control. MRX-8 can operate equipment via RS-232 communication. This allows discrete serial commands to be triggered from a Total Control remote to a MRX-8. The signal is then sent to the device over proprietary URC
  • URC MRX-8 | Owners Manual - Page 9
    TOTAL CONTROL MRX-8 SYSTEM CONTROLLER Using Sensors with the MRX-8 The MRX-8 uses sensors to detect audio, light, video, voltage, current and contact closures to determine the equipment status, query the state of a device or other automation triggers for the equipment it controls. For example, using
  • URC MRX-8 | Owners Manual - Page 10
    TOTAL CONTROL MRX-8 SYSTEM CONTROLLER Wiring to the Relay on the MRX-8 The MRX-8 has a Relay with three or a momentary contact. Using an RFTX-1 for URC One-Way Lighting products The MRX-8 can use an RFTX-1, via the available RFTX-1 port. It controls URC One-Way Lighting products at 418 or 433.
  • URC MRX-8 | Owners Manual - Page 11
    TOTAL CONTROL MRX-8 SYSTEM CONTROLLER Specifications Network: One 10/100 Ethernet port Relay: One relay configurable to be NO, NC or Momentary Sensor: Two Sensors support Video (SEN-VID), Voltage (SEN-VOLT), Audio (SEN-AUD), Current (SEN-CMF), Light (SEN-LITE), and Contact Closure (SEN-CCLS) sensors.
  • URC MRX-8 | Owners Manual - Page 12
    TOTAL CONTROL MRX-8 SYSTEM CONTROLLER Limited Warranty Statement 1. Limited Warranty and Disclaimers Universal Remote Control, Inc. ("URC") warrants that the URC RELIABILITY OR OTHERWISE. EXCEPT AS EXPRESSLY PROVIDED FOR HEREIN, TECHNICAL SERVICES ARE SUPPLIED "AS IS", WITHOUT ANY WARRANTY, EXPRESS,
  • URC MRX-8 | Owners Manual - Page 13
    TOTAL CONTROL MRX-8 SYSTEM CONTROLLER URC WARRANTY CLAIM PROCEDURE. The warranty limitations and warranty disclaimers may not apply to end user in whole URC equipment support and other important information, please visit URC's website available at www.universalremote.com or call the Customer Service
  • URC MRX-8 | Owners Manual - Page 14
    TOTAL CONTROL MRX-8 SYSTEM CONTROLLER URC's PC programmable remotes or any of our Total Control® whole-house equipment are authorized for online internet sales. Buying URC's PC programmable remotes or any of our Total Control® whole-house equipment online means buying equipment that does not have a
  • URC MRX-8 | Owners Manual - Page 15
    TOTAL CONTROL MRX-8 SYSTEM CONTROLLER Federal Communication Commission Interference Statement This equipment has been tested frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee
  • URC MRX-8 | Owners Manual - Page 16
    TOTAL CONTROL MRX-8 SYSTEM CONTROLLER Declaration of Conformity Company Name Company Address Contact Information : +82-54-468-7281, Fax: +82-54-461-8368 : UNIVERSAL remote control : System Controller : MRX-8 This product herewith complies with the requirements of EMC Directive(2004/108/EC) issued
  • URC MRX-8 | Owners Manual - Page 17
    NOTE Page 14
  • URC MRX-8 | Owners Manual - Page 18
    NOTE Page 15
  • URC MRX-8 | Owners Manual - Page 19
    500 Mamaroneck Avenue, Harrison, NY 10528 Phone: (914) 835-4484 Fax: (914) 835-4532 www.universalremote.com OCE-0073k Rev 01
  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
Owner’s Manual
MRX-8
System Controller