Stihl MS 362 C Product Instruction Manual - Page 21
Making Sapwood Cuts, D = Felling Cut, E = Hinge, Warning
![]() |
View all Stihl MS 362 C manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 21 highlights
Making Sapwood Cuts D = Felling Cut E = Hinge E D English D E 001BA150 KN 001BA144 KN 001BA145 KN N For medium sized or larger trees make cuts at both sides of the trunk, at same height as subsequent felling cut N Cut to no more than width of guide bar. This is especially important in softwood in summer - it helps prevent sapwood splintering when the tree falls. Conventional and open-face technique: N Begin 1 to 2 inches (2.5 to 5 cm) higher than center of felling notch. N Cut horizontally towards the felling notch. N Leave approx. 1/10 of diameter uncut. This is the hinge. N Do not cut through the hinge - you could lose control of the direction of the fall. Drive wedges into the felling cut where necessary to control the fall. N Helps control the falling tree. N Do not cut through the hinge - you could lose control of the direction of the fall. Warning! If the tip of the bar contacts a wedge, it may cause kickback. Wedges should be of wood or plastic - never steel, which can damage the chain. MS 362 C 19
![](/manual_guide/products/stihl-ms-362-cq-product-instruction-manual-af952ec/21.png)