Stihl FS 360 C-E Product Instruction Manual - Page 30
Starting / Stopping the, Engine
View all Stihl FS 360 C-E manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 30 highlights
English Disconnecting the machine from the harness Starting / Stopping the Engine 1 1 2 2 N Press the spring on the snap hook (1) and remove the carrying ring (2) from the hook FS 360 C The machine will balance differently depending on the cutting attachment mounted. N Let the machine swing on the harness until it stops moving - change the connection point if necessary Hanging positions Mowing heads, grass cutting blades and brush knives should rest lightly on the ground. 6BA009 KN 002BA391 KN Circular saw blades should "hover" approx. 8 in. (20 cm) above the ground. Disconnecting the machine from the harness N Press the spring on the snap hook and remove the perforated strip from the hook Putting down the machine in an emergency As soon as it becomes apparent that a dangerous situation is developing, the machine must be put down quickly. To put down the machine, proceed as in "Disconnecting the machine from the harness". Practice setting down the machine quickly. In order to avoid damage, when practicing, do not throw the machine on the ground. 6BA010 KN Controls 3 2 1 1 Throttle trigger lockout 2 Throttle trigger 3 Stop switch with Run and Stop positions. Push the stop switch (STOP) to switch off the ignition. Function of stop switch and ignition system The stop switch is normally in the Run position: Ignition is on in this position - the engine is ready to start and may be started. The ignition is switched off when the stop switch is depressed. It is automatically switched on again after the engine comes to a standstill. 002BA392 KN 28 FS 260 C, FS 360 C