Stihl FS 360 C-E Product Instruction Manual - Page 28
Fitting the Full Harness
View all Stihl FS 360 C-E manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 28 highlights
English Checking for proper closure Fitting the Full Harness Fitting the full harness is described in detail in the instruction sheet supplied. FS 260 C 001BA227 KN 001BA223 KN Left: Base of improperly aligned cap (with open space) N The lug on the grip must engage Right: Base of cap correctly posi- 1 entirely in the recess (arrow), and tioned for installation the grip must lie completely flush with the top of the cap. 001BA226 KN 001BA225 KN 002BA386 KN N Grip the cap and check for tightness. N If the cap can be moved, it is not properly installed. Misalignment of the cap parts N If the cap does not drop fully into the opening when the positioning marks line up and/or if the cap does not tighten properly when twisted, the base of the cap may be rotated out of position vis-à-vis the top. N Such misalignment can result from handling, cleaning or an improper attempt at tightening. N To correct a misalignment, turn the cap (with the grip up) until it drops fully into the tank opening. N Twist the cap counterclockwise as far as it will go (approx. 1/4 turn) - this will twist the base of the cap into the correct position. N Twist the cap clockwise, closing it normally - see the sections "Closing" and "Checking for proper closure." N If your cap still does not tighten properly, it may be damaged or broken; immediately stop use of the unit and take it to your authorized STIHL dealer for repair. 2 N Put on the full harness (1). N Adjust the length of the strap so that the carabiner (2) is about a hand's width below your right hip. N Balance the machine - see "Balancing the Machine". 26 FS 260 C, FS 360 C