Stihl FC 75 Instruction Manual - Page 16
Edging, Do not push the blade into
![]() |
View all Stihl FC 75 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 16 highlights
English / USA 241BA003 KN 241BA004 KN 241BA005 KN 1 : Tighten the wingnut clockwise. : Standing in the normal working position, check the depth of cut again and correct it if necessary. 90° Edging : Start the engine. : Start the cut at no less than half throttle and continue cutting at full throttle. : Hold and guide your edger so that the blade is vertical. : Cut steadily so that the engine is not lugged down - do not apply force. : Cut at a normal walking pace. : Do not push the blade into the ground. : Always walk forwards when cutting, do not pull the unit towards you. : Edge at a steady pace to avoid having to make several passes. 1 = Gunning sight for edger blade FC 75 15
![](/manual_guide/products/stihl-fc-75-instruction-manual-fe1abc4/16.png)
15
FC 75
English / USA
:
Tighten the wingnut clockwise.
:
Standing in the normal working
position, check the depth of cut
again and correct it if necessary.
Edging
:
Start the engine.
:
Start the cut at no less than half
throttle and continue cutting at full
throttle.
:
Hold and guide your edger so that
the blade is vertical.
:
Cut steadily so that the engine is not
lugged down – do not apply force.
:
Cut at a normal walking pace.
:
Do not push the blade into the
ground.
:
Always walk forwards when cutting,
do not pull the unit towards you.
:
Edge at a steady pace to avoid
having to make several passes.
1 =
Gunning sight for edger blade
241BA003 KN
241BA004 KN
90°
241BA005 KN
1