Stihl BR 800 C-E MAGNUM Instruction Manual - Page 28
Checking the Spark Plug, WARNING, Installing the Spark Plug
View all Stihl BR 800 C-E MAGNUM manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 28 highlights
English Checking the Spark Plug Installing the Spark Plug 3 1 1 000BA039 KN 0000-GXX-1831-A0 0000-GXX-6234-A0 A 3 4 2 N Clean dirty spark plug. N Check electrode gap (A) and readjust if necessary - see chapter "Specifications." N Use only resistor type spark plugs of the approved range. Rectify problems which have caused fouling of spark plug: - too much oil in fuel mix, - dirty air filter, - unfavorable running conditions, e.g. operating at part load. 2 WARNING To reduce the risk of fire and burn injury, use only spark plugs authorized by STIHL. Always press the spark plug boot (1) snugly onto the spark plug terminal (2). Do not use a spark plug with a detachable SAE adapter terminal (3). Arcing may occur that could ignite combustible fumes and cause a fire. This can result in serious injuries or damage to property. N Only use resistor type spark plugs with solid, non-threaded terminals N Screw the spark plug (4) into the cylinder and fit the boot (3) (press it down firmly). N Fit the cover (2). N Insert and tighten down the screw (1). NOTICE If the blower is operated without the cover (2), the engine may overheat and this can result in engine damage. N Operate your blower only with the cover fitted in position. 26 BR 800, BR 800 X