Sony HT-S100F Operating Instructions - Page 30
Others, Sensors of the TV do not work
View all Sony HT-S100F manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 30 highlights
Make sure you are pressing the correct button on the remote control (page 12). The TV remote control does not work. Install the Bar Speaker so that it does not obstruct the remote control sensor of the TV. This problem might be solved by enabling the IR repeater function (page 16). Others The Control for HDMI function does not work properly. Check the connection with the system (refer to the supplied Startup Guide). Enable the Control for HDMI function on the TV. For details, refer to the operating instructions of your TV. Wait a while, and then try again. If you unplug the system, it will take a while before operations can be made. Wait for 15 seconds or longer, and then try again. Make sure the devices connected to the system support the Control for HDMI function. Enable the Control for HDMI function of the devices connected to the system. For details, refer to the operating instructions of your device. The type and number of devices that can be controlled by the Control for HDMI function is restricted by the HDMI CEC standard as follows: - Recording devices (Blu-ray Disc recorder, DVD recorder, etc.): up to 3 devices - Playback devices (Blu-ray Disc player, DVD player, etc.): up to 3 devices - Tuner-related devices: up to 4 devices - Audio system (receiver/ headphone): up to 1 device (used by this system) All indicators on the Bar Speaker flash, the sound is muted, and buttons on the remote control or Bar Speaker other than (power) do not work. The protection feature is activated. Press (power) to turn the system off and disconnect the AC power cord (mains lead) and check the items below. - Make sure that the ventilations of the Bar Speaker are not covered and turn on the system after a while. - When the system is using the USB connection, remove the USB device and turn on the system. If the system operates properly, the current of the connected USB device is over the maximum output current of the system 500 mA, or the USB device may have an abnormality. Sensors of the TV do not work properly. The Bar Speaker may block some sensors (such as the brightness sensor), the remote control receiver of your TV or the emitter for 3D glasses (infrared transmission) of a 3D TV that supports the infrared 3D glass system, or wireless communication. Move the Bar Speaker away from the TV within a range that allows those parts to operate properly. For the locations of the sensors and remote control receiver, refer to the operating instructions supplied with the TV. 30US