Sharp XG-NV5XB Operation Manual - Page 29
Saving and Selecting Adjustment Settings, Mode Adjustment
View all Sharp XG-NV5XB manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 29 highlights
Computer Image Adjustments 2 Projector 1, 6 ON VOL MUTE OFF BLACK SCREEN LASER TOOLS MENU 2, 3, 4 5 R-CLICK ENTER INPUT IrCOM FREEZE AUTO SYNC (GUI) On-screen Display 3 4 Mode Adjustment MOUSE ADJ. Saving and Selecting Adjustment Settings This projector allows you to store up to seven adjustment settings for use with various computers. Once these settings are stored, they can be easily selected each time you connect the computer to the projector. Saving the adjustment setting (For use with the "Power" remote control, slide the MOUSE/ADJUSTMENT switch to the ADJ. position.) 1 Press MENU. 2 Press ß/© to select "Fine Sync". 3 Press ∂/ƒ to select "Save Setting", and then press ©. 4 Press ∂/ƒ to select the desired memory location of the setting. 5 Press ENTER to save the setting. 6 To exit from the GUI, press MENU. Selecting a saved setting (For use with the "Power" remote control, slide the MOUSE/ADJUSTMENT switch to the ADJ. position.) 1 Press MENU. 2 Press ß/© to select "Fine Sync". 3 Press ∂/ƒ to select "Select Setting", and then press ©. 4 Press ∂/ƒ to select the desired memory setting. 5 Press ENTER to select the setting. 6 To exit from the GUI, press MENU. • If the memory position has not been set, the resolution and frequency will not be displayed. • When selecting the stored adjustment setting with "Select Setting", the computer system should match the stored setting. Mode Adjustment Used to display image in the text and graphic modes. CONNECTING TO IBM-PC COMPUTERS • Ordinarily, the type of input signal is detected and the correct resolution mode (Text or Graphics) is automatically selected. However, for the following signals, set "Mode" on the "Fine Sync" menu screen to "ON" or "OFF" to select the projector's resolution mode to match the computer display mode properly. (For use with the "Power" remote control, slide the MOUSE/ADJUSTMENT switch to the ADJ. position.) 1 Press MENU. 2 Press ß/© to select "Fine Sync". 3 Press ∂/ƒ to select "Mode". 4 Press ß/© to select "ON" for graphic mode (640 dots ן350 lines, 640 dots ן400 lines or 1,152 dots ן864 lines, 60 Hz) or "OFF" for text mode (720 dots ן350 lines, 720 dots ן400 lines or 1,024 dots ן864 lines, 60 Hz). (For IBM-PC) Press ß/© to select "ON" when connecting to a Macintosh II with 35 kHz dot frequency or "OFF" when connecting to a Macintosh LC Series computer with 34.79 kHz dot frequency. (For Macnitosh LC Series) 5 Press ENTER to save the setting. 6 To exit from the GUI, press MENU. • When connecting third party video board and other Macintosh computers, set "Mode" on the "Fine Sync" menu screen to "ON" or "OFF" to select the correct display mode. • Avoid displaying computer patterns which repeat every other line (horizontal stripes). (Flickering may occur, making the image hard to see.) E-28 Operation