Sharp SD-HX600 SD-HX600 Operation Manual - Page 21
Antenna connection
![]() |
View all Sharp SD-HX600 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 21 highlights
! Connecting speaker wires Make sure to leave the AC power cord disconnected when connecting the speakers. Connect the speaker wires to the speakers first, then to the unit. When using a speaker wire: 1 Strip the speaker wire about 5/8" (15 mm) and twist the conductors. 2 Loosen the speaker terminal. 3 Insert the speaker wire and tighten the thumbscrew. Approx. 5/8" (15 mm) Caution: " Use a speaker system which has 100 W or more rated power input and 4 - 8 ohm impedance. " If the volume is turned up too high with the speakers of less than 4 ohm impedance connected, the protection circuit of the amplifier is activated. No sound is produced temporarily. " Do not mistake the and , and right and left terminals of the speaker wires. (The right speaker is placed on the right when you face the unit.) " Do not short-circuit the speaker wire. If it happens with the power on, the protection circuit is activated and the unit is set to the power stand-by mode. In this case, check that the speaker wire is connected correctly before turning on the power again. Incorrect " When the center and surround speakers and subwoofer are not connected, set the speaker size to "C-NO", "S-NO" and "SW-NO". Otherwise, the protection circuit may be activated and the power is turned off. Antenna connection Supplied FM antenna: Connect the FM antenna wire to the FM 75 FM antenna OHMS jack and position the FM antenna wire in the direction where the strongest signal can be received. Black Supplied AM loop antenna: Connect the AM loop antenna wire to the AM and GND terminals. Position the AM loop anten- na for optimum reception. Place the AM loop an- tenna on a shelf, etc., or attach it to a stand or a wall with screws (not supplied). AM loop antenna White Note: Placing the antenna on the unit or near the AC power cord may cause noise pickup. Place the antenna away from the unit for better reception. Installing the AM loop antenna: < Assembling > < Attaching to the wall > Wall Screws (not supplied) Outdoor FM or AM antenna: Use an outdoor FM or AM antenna if you require better reception. Consult your dealer. When using an outdoor AM antenna, be sure to keep the wire of the AM loop antenna connected. Outdoor FM antenna Outdoor AM antenna 49 feet (15 m) 25 feet (7.5 m ) Ground rod Ground wire AM loop antenna Preparation for Use - Speaker connection / Antenna connection - SD-HX600 ENGLISH E-16
![](/manual_guide/products/sharp-sdhx600-sdhx600-operation-manual-38c46c7/21.png)