Sharp PN-HM851 PN-HB Series PN-HM Series Operation Manual - Page 16
Preparing the Remote Control Unit, Installing the batteries, Remote control operation range
![]() |
View all Sharp PN-HM851 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 16 highlights
Preparing the Remote Control Unit Installing the batteries 1. Place your finger on the part marked with the ▲, and then pull the cover off. 2. See the instructions in the compartment and put in the supplied batteries (R03 ("AAA" size) x 2) with their plus (+) and minus (-) sides oriented correctly. 3. Close the cover. TIPS • When the batteries become exhausted, replace them with new (commercially available) batteries. • The supplied batteries may become exhausted quickly depending on how they are stored. • If you will not be using the remote control for a long time, remove the batteries. • Use manganese or alkaline batteries only. Remote control operation range Remote control sensor in The remote control can be operated even when the remote control sensor is stored inside the monitor. Point the remote control unit toward the remote control sensor on the bottom of the monitor (or the right side of the monitor if using portrait orientation). For the monitor in landscape orientation For the monitor in portrait orientation 9.8 feet (3m) 20º 10º 10º 9.8 feet (3m) 10º10º Remote control sensor 9.8 feet (3m) 20º 10º10º 9.8 feet (3m) 10º 10º Remote control sensor E 16
![](/manual_guide/products/sharp-pnhb651-pnhb-series-pnhm-series-operation-manual-8fe45f4/16.png)