Sharp PG-M10XL PG-M10SU , PG-M10XU Operation Manual - Page 38

When the STATUS Indicator Illuminates or Flashes STATUS indicator POWER STATUS ON/OFF INPUT SELECT AUTO SYNC Status Light Messages Condition Status OFF Normal On Continually The lamp usage has exceeded 1000 hours of operation and should be replaced. Flashing Very Rapidly (On and off in a cycle of 1 sec.) • The lamp cover is not correctly attached. Replace it correctly. Flashing Rapidly (On and off in a cycle of 4 sec.) • The temperature protector has been triggered. If the room temperature is high, move the unit to a cool location. If the temperature within the unit is high, check the cooling fan (exhaust vent) and the cooling fan (exhaust vent) on the bottom of the unit. If any of the slots are blocked, remove whatever is blocking them. • The temperature protector has been triggered. If you try to turn on the unit immediately after turning off, sometimes the power does not come on. If this happens, wait at least one minute, then turn on the unit again. • The lamp lighting voltage error detection protector has been triggered. Wait at least one minute before turning on the unit again. If this does not solve the problem, please contact your dealer. Flashing Slowly (On and off in a The cooling fan has stopped. Contact your Sharp Authorized LCD Projector cycle of 8 sec.) Dealer or Service Center. Flashing Very Slowly (On and off in a cycle of 12 sec.) The lamp is not turned on. • The unit was turned on immediately after being turned off. Turn off the unit, wait at least one minute, then turn on the unit again. • The lamp is dead. Replace the lamp cage. (See page 37.) 36 Others