Sharp PG-M10XL PG-M10SU , PG-M10XU Operation Manual - Page 20

Basic Operation Using the unit Before Using, open the sliding lens cap. 1 Connect the power cord. The POWER indicator will illuminate orange in color indicating that the unit is in standby status. The cooling fan will operate at slow speed. Illuminates in orange (Standby) POWER STATUS ON/OFF INPUT S POWER STATUS ON/OFF INPUT SELECT AUTO SYNC COMPUTER MOUSE AUDIO VIDEO S VIDEO 1 Power cord (supplied) 2 To wall outlet The configuration of wall outlets differs from country to country. Use the power cord that corresponds to the wall outlet in your country. 2 Press the POWER ON/OFF button on the remote control, or the POWER ON/OFF button on top of the unit, to turn on the unit. The POWER indicator on top of the unit turns to green and starts flashing. It takes one minute for the unit to be ready for use. Wait until the indicator stops flashing and illuminates steadily in green. This will prevent the unit from accidental shutoff. MOUSE ON/OFF VIDEO MENU R-CLICK/EXIT COMPUTER POWER STA ON/OFF Green light flashes (About one minute) ↓ Then illuminates steadily in green • While the POWER indicator is flashing, the unit doesn't turn off even if you press the POWER ON/OFF button on the remote control, or the POWER ON/OFF button on the unit. 3 Turn on the connected source (computer, VCR, DVD player, etc.). If you use a video component, start playback for screen/image adjustment. 4 Select the input by pressing either the VIDEO or COMPUTER button of the remote control, or the INPUT SELECT button of the unit (refer to page 20). MOUSE ON/OFF VIDEO MENU R-CLICK/EXIT COMPUTER POWER STA ON/OFF • If no signal is being sent to the unit, the blue or black screen (the background type differs depending on the "BACKGROUND" setting. See page 32.) is projected. Check the following: - Is the source properly connected to the unit? - Is the source component or computer turned on? • The video resolution of the connected computer can be changed. See page 17. 5 Adjust the position and height of the unit. Move the unit to the position where the projected image is horizontally centered to the screen. • When the projected image is offset horizontally Adjust the position of the unit so that the unit is square to the screen. View from the top Screen • When the projected image is offset vertically Adjust the height balance of the unit with the adjusters. See next page. Side view Screen 18