Sharp MX-M5071 User Manual - Page 183

COPIER►BEFORE USING THE MACHINE AS A COPIER SELECTING THE PAPER TRAY FOR COPYING The machine is set to automatically select a tray that has the same size of paper as the size of the placed original (Auto Paper Select). If the original size cannot be detected correctly because it is a non-standard size or when you want to change the paper size for copying, you can select the paper tray manually. • If the selected tray runs out of paper during a copy job and there is another tray that has the same size and type of paper, that tray will be automatically selected and the copy job will continue. • If a suitable size of copy paper is not loaded, copying may stop. • To change the initially selected tray: In "Settings (administrator)", select [System Settings] → [Copy Settings] → [Initial Status Settings] → [Paper Tray]. • Stop auto paper selection In "Settings (administrator)", select [System Settings] → [Copy Settings] → [Common Settings] → [Disabling of Auto Paper Selection] The same size of paper will not be automatically selected when an original is placed on the document glass or the document tray of the Single Pass Feeder. • Automatically select the tray used for paper feeding In "Settings (administrator)", select [System Settings] → [Copy Settings] → [Common Settings] → [Auto Selection Setting of Tray that is Supplied the Paper] When this setting is enabled and paper is loaded into a tray while the machine is on standby in copy mode, that tray is automatically selected. 1 Tap the [Paper Select] key. ► COPYING SEQUENCE (page 2-5) 2 Tap the required tray key. After the settings are completed, tap . In Easy mode Paper Select 1 8½x11 2 8½x11R 3 8½x14 4 11x17 Auto 8½x11 Plain 1 Type and Size CCAA PPrreevviieeww CCooppiieess 1 B/W StaCrotlor Start Start In Normal mode Paper Select Paper Tray 1 8½x11 Plain 1 2 8½x11R Plain 1 8½x14 3 Plain 1 11x17 4 Plain 1 Tray 1 : Plain (60 - 89g/m2) Others No. of copies 1 Auto Bypass Tray 8½x11 Plain 1 Type and Size 3 8½x14 4 11x17 Change Current Type and Size of Selected Tray Original Change Size/Direction. Copy Ratio Enlarge/Reduce Copy 2-Sided Copy Margin Shift Shift Position to Have Margin Preview CA Start • When the bypass tray is selected, specify the paper type and size based on the paper loaded into the bypass tray. ► SPECIFYING A TYPE AND SIZE OF PAPER LOADED ON BYPASS TRAY (page 2-35) • In normal mode, you can also open the [Paper Select] screen by tapping the machine image on the base screen. To automatically select the tray, tap the [Auto] key. 2-12