SanDisk 8GB ULTRA Product Manual - Page 74
Set Features-EFH
UPC - 619659021566
View all SanDisk 8GB ULTRA manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 74 highlights
ATA Command Description SanDisk CompactFlash Card OEM Product Manual 5.1.18 Set Features-EFH This command is used by the host to establish or select certain features. Table 5-26 Set Features Bit 7 6 5 4 3 2 1 0 Command (7) EFH C/D/H (6) X Drive X Cyl High (5) X Cyl Low (4) X Sec Num (3) Sec Cnt (2) X Config Feature (1) Feature Table 5-27 defines all features that are supported. The 9AH feature is unique to CompactFlash Memory cards and are not part of the ATA Specification. Table 5-27 Features Supported Feature 01h 02h 03h 55h 66h 69h 81h 96h 9Ah BBh CCh Operation Enable 8-bit data transfer Enable Write Cache Set Transfer Mode based on value and Sector Count register. Disable Read Look Ahead Disable Power on Reset (POR) establishment of defaults at Soft Reset Accepted for backward compatibility with the SDP Series but has no impact on the CF Memory Card. Disable 8-bit data transfer Accepted for backward compatibility with the SDP Series but has no impact on the CF Memory Card Accepted for backward compatibility with the SDP Series but has no impact on the CF Memory Card 4 bytes of data apply on Read/Write Long commands Enable Power on Reset (POR) establishment of defaults at Soft Reset. Features 01H and 81H are used to enable and clear 8-bit data transfer mode. If the 01H feature command is issued, all data transfers will occur on the low order D7-D0 data bus and the IOIS16 signal will not be asserted for data register accesses. 02/07, Rev. 12.0 5-20 © 2007 SanDisk Corporation