Rane TTM 56S Operation Manual - Page 4
Faders, Meters - performance mixer
View all Rane TTM 56S manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 4 highlights
0 10 AUX IN L PAN R DRY WET L PAN R MA CHANNEL REVERSE switch allows the left-hand or right-hand Fader to alternately control PGM 1 or PGM 2. (Don't confuse with the program fader REVERSE switch, see below.) TTM 56 PERFORMANCE MIXER CHANNEL REVERSE PGM 1 REVERSE MODE 1 MODE 2 TRANSFORM TRANSFORM REVER MODE 1 MODE 2 TRANSFORM switches provide two functions: • PHONO / LINE source selection for PGM 1 and 2. • Quick cut between the used and unused input. The switches are easily field replaceable and may be rotated in 45° increments. See page Manual-10 for instructions. FAST CONTOUR SLOW Faders The program faders and crossfader are magnetic, non-contact faders. This means No travel noise or bleed ! The electrical performance of the faders is unaffected by use. The program faders and crossfader each have their own CONTOUR, REVERSE (hamster) and MODE controls. Magnetic faders are very different from what you are used to. Read Maintaining Magnetic Faders on pages Manual 8-9. Program fader MODE switches: allow selecting two sets of curves. MODE 1 gives the familiar stereo fader response. MODE 2 gives left/right pan effect. MONO PGM1 / PGM2 STEREO HOUSE CO +10 +7 +4 +2 0 -2 -4 -7 -10 -20 REVERSE MODE 1 MODE 2 A B Program fader CONTOUR controls: allow smooth, continuous adjustment of contour for both MODE 1 and MODE 2. The range of control is from SLOW blend to FAST cut. Program fader REVERSE switches change the direction of the program faders. When the reverse switch is engaged, up is down and down is up (hamster). CROSSFADER MODE switch allows selecting two sets of crossfader curves. MODE 1 gives the familiar PGM 1 / PGM 2 crossfade response. MODE 2 gives a center cut response (PGM 1 and PGM 2 off in the center). Meters Meters provide switchable true stereo Master Mix or dualmono PGM1 / PGM2 indication of Pre-Program fader signal levels. Ten-segment resolution is provided with a one second, peak hold. Use the meter to set the GAIN controls. With the program fader set to maximum, the input GAIN should be set to indicate an average level of about +4 dB. CROSSFADER CONTOUR A & B provide independent control for each side of the crossfader. This allows a fast cut on one side and slow blending on the other (or any combination you choose). CONTOUR A CROSSFADER REVERSE MODE CONTOUR B Manual-