Rane Sixty-One Sixty-One Mixer Manual for Serato DJ - Page 16

OWNER'S MANUAL FlexFx The FlexFx Bus in the Sixty-One works differently than a typical effects insert loop. This architecture is very flexible and opens up many new possibilities not possible with simple effect insert designs found on other mixers. The FlexFx Bus is more like an auxiliary bus that can have multiple signals assigned to it. Signals assigned to the bus may then have external analog effects and external USB effects applied in any combination. The order of processing in the FlexFx Bus is shown in the graphic below. 1. FLEXFX buttons for DECK 1, DECK 2, MIC and AUX assign signals to the FlexFx Bus (BRIGHT BLUE) or the Main Mix (dim blue). This allows assigning multiple inputs to the FlexFx Bus and/or changing the assignment without interrupting audio. 2. ANALOG INSERT is turned on/off with a separate button. The external analog insert can be used with the INSERT or independently. NOTE: If no external connection is made to the FLEXFX LOOP RETURN jack, the signal will be interrupted when the ANALOG INSERT button is turned on. 3. The INSERT is turned on/off with a separate button, used with the ANALOG INSERT or independently. The INSERT uses USB record pair 9-10 for the Send, and USB playback pair 7-8 for the Return. Using the INSERT generally requires a low latency setting. Adjust latency in the "Rane Drivers" on page 17. NOTE: Assign a Deck channel or signal to FLEXFX before engaging the INSERT button to avoid audible artifacts. 4. The FlexFX CUE is after the analog external insert, USB insert and before the WET / DRY control. This allows cueing a Wet signal while listening to the Dry signal before fading up to Wet. 1 DECK 1 FLEXFX DECK 2 FLEXFX MIC FLEXFX AUX FLEXFX 2 SEND RIGHT LEFT SEND RETURN ANALOG INSERT RETURN RIGHT LEFT 3 USB Record SEND RETURN INSERT USB Playback 4 DRY Main Mix WET CUE Cue Bus FLEXFX SIXTY-ONE 16